How to install side step honda pilot

What would you like your bulbs to do? Reina helped make these videos. The video above shows you how to change the parking light bulb in your Honda Pilot. The parking light is typically orange in color and in some Pilots is the same bulb as the turn signal. The parking light bulb grows dimmer over time and we recommend that you change both bulbs on your Pilot at the same time, even if only one is burnt out.

It is possible for the turn signal portion of the bulb to burn out and for the parking light to continue to function properly and vice versa - replacing the bulb will restore functionality of both in your Pilot.

When changing the parking light in your Pilot, be careful not to touch the glass part of the new bulb with your finger as this will cause it to burn out quicker. We recommend using gloves or a piece of paper towel to limit the potential of touching the bulb. Hans Angermeier has produced over , videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Did you know that the sun wears out wiper blades faster than rain?

Find My Accessories. Black Running Boards gives your Pilot a super-aggressive look while increasing side splash protection. These Running Boards give your Pilot a super-aggressive look while increasing side splash protection. The main structure is lightweight extruded aluminum for strength and corrosion resistance Custom-integrated design ensures a solid fit Polished stainless steel trim with custom step plate provides added eye appeal. Driver Side - Air Intake. Pry Up Center of Fastener.

Pry Out 2nd Fastener. Pry Up Base of Fastener. Lift Air Intake Assembly. To access the headlight bulbs on the driver side of the vehicle, you'll need to remove the air intake assembly. Air Intake Hose Removed. Two Pop Rivets Removed. Low Beam - Near Middle. Set the air intake assembly aside in a safe place. Base of Low Beam Bulb. Release Power Plug. Reach in behind the headlight housing and press the release tab on the electrical connector before sliding the power plug straight off the base of the old low beam bulb.

Remove Old Low Beam. Low Beam Bulb Socket. Install New H11 Bulb. Push On Electrical Connector. Try to avoid touching the new halogen bulb with your fingers or anything greasy in the engine bay. Turn Signal Bulb Socket.

The Front Turn Signal light bulb is located at the top inner corner of the headlight housing. Pull Out Old Bulb. Push In New A. Turn Signal Housing. Pull the old bulb straight out of the socket and push in a new amber colored number NA or A bulb.

Base of High Beam Bulb.